
Table 12: 3G ExpressCard Physical Specifications (continued)
ValueSpecification
•
3.3 V (primary source)
•
1.5 V (secondary source)
Voltage supply
Related
Documentation
SRX210 Services Gateway 3G ExpressCard Basic CLI Commands on page 27•
• Installing the 3G ExpressCard in the SRX210 Services Gateway ExpressCard Slot on
page 26
• SRX210 Services Gateway Front Panel and Back Panel Views (Low Memory, High
Memory, and PoE Versions) on page 9
Installing the 3G ExpressCard in the SRX210 Services Gateway ExpressCard Slot
TIP: Placing the SRX210 Services Gateway on a flat, level surface, with the
Juniper Networks logo facing up, will make it easier to align and insert the 3G
ExpressCard in the ExpressCard slot.
CAUTION: 3G ExpressCard is not hot-swappable on the SRX210 Services
Gateway.
To install the 3G ExpressCard in the ExpressCard slot on the SRX210 Services Gateway:
1. Align the 3G ExpressCard as follows:
•
Ensure that the 3G ExpressCard is parallel with the surface on which the SRX210
Services Gateway is placed.
•
Ensure that the center of the 3G ExpressCard is aligned with the center of the
ExpressCard slot on the SRX210 Services Gateway.
2. Study Figure 11 on page 27, which shows installation of the 3G ExpressCard on the
SRX210 Services Gateway.
Copyright © 2013, Juniper Networks, Inc.26
SRX210 Services Gateway Hardware Guide
Comentarios a estos manuales