Juniper-networks SRX 210 Manual de usuario Pagina 157
- Pagina / 176
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
SRX210 Services Gateway Power Specifications and Requirements
The AC power system electrical specifications for the SRX210 Services Gateway are
listed in Table 41 on page 141.
Table 41: Power Supply Electrical Specifications for the SRX210 Services
Gateway
SpecificationPower Requirement
100 to 240 VACAC input voltage
50 to 60 HzAC input line frequency
1.5 A maximum
2.5 A maximum (for PoE models)
AC system current rating
WARNING: The AC power cord for the services gateway is intended for use
with the device only and not for any other use.
Related
Documentation
SRX210 Services Gateway Power Supply on page 19•
• SRX210 Services Gateway Site Electrical Wiring Guidelines on page 139
• SRX210 Services Gateway Grounding Specifications on page 141
• Interface Cable and Wire Specifications for the SRX210 Services Gateway on page 143
SRX210 Services Gateway Grounding Specifications
To meet safety and electromagnetic interference (EMI) requirements and to ensure
proper operation, the services gateway must be adequately grounded before power is
connected. A grounding point available on the rear of the services gateway chassis is
used to connect the device to earth ground.
WARNING: Before device installation begins, a licensed electrician must
attach a cable lug to the grounding and power cables that you use. A cable
with an incorrectly attached lug can damage the device (for example, by
causing a short circuit).
To ground the device before connecting power, you connect the grounding cable to earth
ground and then attach the lug on the cable to the chassis grounding point with the
screw.
Table 42 on page 142 lists the specifications for the grounding cable used with the device.
141Copyright © 2013, Juniper Networks, Inc.
Appendix B: SRX210 Services Gateway Power Guidelines, Requirements, and Specifications
- SRX210 Services Gateway 1
- END USER LICENSE AGREEMENT 2
- Table of Contents 5
- Part 4 Appendixes 8
- Part 5 Index 9
- About This Guide 11
- Table 1: Notice Icons 12
- Obtaining Documentation 13
- Documentation Feedback 14
- Requesting Technical Support 14
- CHAPTER 1 19
- Components and Specifications 23
- ValueSpecification 24
- Memory, and PoE Versions) 25
- ComponentNumber 26
- Interfaces (continued) 28
- SRX210 Services Gateway LEDs 29
- Front Panel LEDs 30
- LEDs (continued) 31
- Ethernet Port LEDs 31
- Table 10 on page 16 32
- Boot Devices 33
- Dual-Root Partitioning Scheme 33
- Air flow 35
- CAUTION: 37
- ATTENTION: 37
- CHAPTER 3 39
- Introduction 39
- Supported Modem Types 39
- Services Gateway 40
- Using the 3G ExpressCard 40
- Key Features 40
- Physical Specifications 41
- CommandAction 43
- CDMA ExpressCards 43
- Commands (continued) 44
- Ethernet Support 45
- PoE Classes and Power Ratings 46
- Gateway (continued) 47
- Interface Modules 49
- Gateway Installation 53
- Installation (continued) 54
- Requirements 56
- Requirement for Clearance 58
- Recommended 58
- ClearanceLocation 58
- Documentation 59
- CHAPTER 8 63
- CHAPTER 9 65
- QuantityComponent 66
- QuantityPart 67
- Installation 69
- Rack-Mount Installation 70
- Desk-Mount Installation 71
- Wall-Mount Installation 72
- CHAPTER 11 73
- 60-Watt Power Supply 74
- 150-Watt Power Supply 75
- Mounting Brackets 76
- Services Gateway in a Rack 77
- Power Supply Adapter Tray 77
- Vertical Stand 79
- Services Gateway on a Desk 79
- Services Gateway on a Wall 81
- CHAPTER 12 83
- Autoinstallation 91
- CHAPTER 14 93
- 192.168.1.1 and use DHCP to 94
- ValuePort Settings 96
- Gateway End 97
- CHAPTER 15 101
- J-Web Interface 107
- Start to 109
- Your ActionFunctionField 110
- Services Gateway Hardware 113
- Hardware Components 115
- Components (continued) 116
- CHAPTER 17 117
- Possible Causes and 119
- Corrective Actions 122
- Possible Cause and Corrective 124
- ActionMeaningLED Status 124
- Appendixes 127
- Information 129
- Qualified Personnel Warning 132
- ADSL 2/2+ A 135
- Class 1 Laser Product Warning 141
- Class 1 LED Product Warning 141
- Laser Beam Warning 142
- Warnings 143
- Jewelry Removal Warning 144
- Lightning Activity Warning 146
- Operating Temperature Warning 146
- Product Disposal Warning 147
- Korean Class B Warning 151
- SRX210 Services Gateway Power 155
- Guidelines, Requirements, and 155
- Specifications 155
- GuidelineSite Wiring Factor 156
- 1.5 A maximum 157
- AC system current rating 157
- Grounding lug 158
- APPENDIX C 159
- Port (10/100 Mbps) 160
- Port (1 Gbps) 160
- Port (1 Gbps) (continued) 161
- Hardware 163
- Power Supply 0 165
- Contacting Customer Support 166
- Packing the Services Gateway 167
- Index on page 155 169
Relacionado con productos y manuales para Hardware Juniper-networks SRX 210
Hardware Juniper-networks M5 Manual de usuario
(205 paginas)
(205 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.200 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales