Juniper-networks SRX 210 Manual de usuario Pagina 27

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 176
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 26
NOTE: The cable tie holder provides support to hold the power cord on to
the power supply point.
The lock provides the capability to lock and secure the device to the
installation site.
Related
Documentation
SRX210 Services Gateway Built-In Interfaces on page 11
SRX210 Services Gateway LEDs on page 13
SRX210 Services Gateway Boot Devices and Dual-Root Partitioning Scheme on page 17
SRX210 Services Gateway Cooling System on page 18
SRX210 Services Gateway Power Supply on page 19
SRX210 Services Gateway Built-In Interfaces
Table 8 on page 11 summarizes the interface ports supported on the SRX210 Services
Gateway.
Table 8: SRX210 Services Gateway Built-In Hardware Interfaces
DescriptionSpecificationsInterface Type
The Gigabit Ethernet ports can
be used as follows:
To function as front-end
network ports
To provide LAN and WAN
connectivity to hubs,
switches, local servers, and
workstations
To forward incoming data
packets to the device
To receive outgoing data
packets from the device
To connect power devices
to receive network
connectivity and electric
power (PoE functionality)
(For the PoE model of the
SRX210 Services Gateway)
Consist of two fixed ports
Are labeled as port 0/0 and
port 0/1 on the front panel
Use an RJ-45 connector
Provide link speeds of
10/100/1000 Mbps
Operate in full-duplex and
half-duplex modes
Support flow control
Support autonegotiation
and autosensing
Both Gigabit Ethernet ports
support Power over Ethernet
on the PoE models of the
SRX210 Services Gateway.
Gigabit Ethernet
11Copyright © 2013, Juniper Networks, Inc.
Chapter 2: SRX210 Services Gateway Hardware Components and Specifications
Vista de pagina 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 175 176

Comentarios a estos manuales

Sin comentarios