Juniper Networks FI-6000NS Manual de usuario descargar pdf (Pagina 269)

6.3 Network Connection Troubleshooting

Network Scanner fi-6000NS Operator's Guide 243

Troubleshooting

6

4 Another host or communication device is

connected using the same IP address as the

scanner.

If the same IP address has already been used

by another host or communication device, then

even if the other device has been given a

different IP address the remote computer may

not recognize the scanner’s "duplicate" IP

address until it is rebooted. Restart the remote

computer.

If a duplicate IP address connection from

another host or communication device exists

on a LAN, both it will be unusable.

If a duplicate IP address connection from

another host or communication device exists,

pull out its LAN cable and restart the remote

computer.

5 Access is denied due to the establishment of a

firewall between the remote computer and the

scanner.

If a firewall has been established between the

remote computer and the scanner, check that it

has not been set to deny access to the network.

6 The network link speed/duplex mode for the

scanner and remote computer are different, or

Auto-Negotiation is not supported by the

remote computer.

For this scanner, the default [Link Speed/

Duplex Mode] setting is "Auto-Negotiation".

On the "Network Status" screen, match the

scanner and remote computer's network link

speed/duplex mode settings.

If the problem persists in spite of having set

both the scanner and remote computer's

network link speed/duplex settings to "Auto-

Negotiation", select something other than

"Auto-Negotiation" and check again.

For more details about the "Network Status"

screen, refer to "3.6.11 Checking the Network

Operating Status" (page 89).

No. Problem Action

1 2 ... 264 265 266 267 268 269 270 271 272 273 274 ... 356 357

Comentarios a estos manuales

Sin comentarios