Juniper Networks EX3200 Manual de usuario descargar pdf (Pagina 67)

Table 15: Network Port Connector Pinout Information for an EX3200 or EX4200 Switch (continued)

DescriptionSignalPin

Transmit/receive data pair 4TRP4-8

Related Topics Front Panel of an EX3200 Switch on page 8■

■ Front Panel of an EX4200 Switch on page 10

Console Port Connector Pinout Information for an EX Series Switch

The console port on an EX Series switch is an RS-232 serial interface that uses an

RJ-45 connector to connect to a console management device. The default baud rate

for the console port is 9600 baud.

Table 16 on page 41 provides the pinout information for the RJ-45 console connector.

An RJ-45 cable and an RJ-45 to DB-9 serial port adapter are supplied with the switch.

NOTE: If your laptop or PC does not have a DB-9 male connector pin and you want

to connect your laptop or PC directly to an EX Series switch, use a combination of

the RJ-45 to DB-9 female adapter supplied with the switch and a USB to DB-9 male

adapter. You must provide the USB to DB-9 male adapter.

Table 16: EX Series Switches Console Port Connector Pinout Information

DescriptionSignalPin

Request to sendRTS Output1

Data terminal readyDTR Output2

Transmit dataTxD Output3

Signal groundSignal Ground4

Signal groundSignal Ground5

Receive dataRxD Input6

Data carrier detectCD Input7

Clear to sendCTS Input8

Related Topics ■ See Rear Panel of an EX2200 Switch for port location.

■ See Rear Panel of an EX3200 Switch on page 9 for port location.

■ See Rear Panel of an EX4200 Switch on page 11 for port location.

Console Port Connector Pinout Information for an EX Series Switch ■ 41

Chapter 3: Component Specifications

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 283 284

Sin comentarios

Juniper Networks EX3200 Manual de usuario Pagina 67