Juniper Networks EX3200 Manual de usuario descargar pdf (Pagina 159)

Figure 48: Installing a Fan Tray in an EX4200 Switch

Related Topics ■ Removing a Fan Tray from an EX3200 or EX4200 Switch on page 174

■ Installing and Removing EX3200 and EX4200 Switch Hardware Components on

page 129

■ Cooling System and Airflow in an EX3200 Switch on page 31

■ Cooling System and Airflow in an EX4200 Switch on page 32

■ Field-Replaceable Units in EX3200 and EX4200 Switches on page 16

■ Rear Panel of an EX3200 Switch on page 9

■ Rear Panel of an EX4200 Switch on page 11

Installing an Uplink Module in an EX3200 or EX4200 Switch

If your EX3200 or EX4200 switch includes an optional field-replaceable unit (FRU)

uplink module, you install it in the switch's front panel. The different types of uplink

modules are described in “Uplink Modules in EX3200 and EX4200 Switches” on

page 33.

The uplink module in EX3200 and EX4200 switches is a hot-removable and

hot-insertable FRU: You can remove and replace it without powering off the switch

or disrupting switch functions.

NOTE: If you have set an uplink module port as a Virtual Chassis port (VCP), removing

the uplink module breaks the setting. You must reset the port as a VCP after you

replace the module. See Setting an Uplink Module Port as a Virtual Chassis Port (CLI

Procedure).

Installing an Uplink Module in an EX3200 or EX4200 Switch ■ 133

Chapter 10: Installing Switch Components

1 2 ... 154 155 156 157 158 159 160 161 162 163 164 ... 283 284

Sin comentarios

Juniper Networks EX3200 Manual de usuario Pagina 159