Juniper-networks JUNOS OS 10.4 Manual de usuario Pagina 197
- Pagina / 208
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Interface STP index Forward State
ge-2/0/5 24 forwarding
ge-2/1/1 25 forwarding
Meaning The output displayed shows the STP index number used by each interface in ring instances
ring-1 and ring-2. The STP index controls the forwarding behavior for a set of VLANs on
the data channel of a ring instance on a ring interface. For ring instances, there are multiple
STP index numbers (here representing VLANs 200, 300, 500, and 600). The Forward
State shows whether the data channel is forwarding or discarding traffic. All data channels
are forwarding traffic.
Verifying the VLANs on AS1
Purpose Verify the data channel logical interfaces and the VLAN IDs controlled by a ring instance
data channel.
Action List dynamic VLAN membership:
user@as1>show protection-group ethernet-ring vlan
Ethernet ring IFBD parameters for protection group ring-1
Interface Vlan STP Index Bridge Domain
ge-2/0/5 200 22 default-switch/bd200
ge-2/1/1 200 23 default-switch/bd200
ge-2/0/5 300 22 default-switch/bd300
ge-2/1/1 300 23 default-switch/bd300
Ethernet ring IFBD parameters for protection group ring-2
Interface Vlan STP Index Bridge Domain
ge-2/0/5 500 24 default-switch/bd500
ge-2/1/1 500 25 default-switch/bd500
ge-2/0/5 600 24 default-switch/bd600
ge-2/1/1 600 25 default-switch/bd600
Meaning The output displayed shows the ring interfaces ge-2/0/5 and ge-2/1/1 in protection groups
ring-1 and ring-2. For ring-1, VLAN 200 and VLAN 300 are being supported on both STP
Index 22 and 23 on bridge domains bd200 and bd300. For ring-2, VLAN 500 and VLAN
600 are being supported on both STP Index 24 and 25 on bridge domains bd500 and
bd600. The data channel controls the traffic on the VLAN IDs to facilitate load-balancing.
Related
Documentation
Ethernet Ring Protection Using Ring Instances for Load Balancing on page 153•
• Ethernet Ring Protection on page 151
Example: Viewing Ethernet Ring Protection Status—Normal Ring Operation
Under normal operating conditions, when Ethernet ring protection is configured correctly,
the ring protection link (RPL) owner (Router 1 in the configuration example) will see the
following:
177Copyright © 2013, Juniper Networks, Inc.
Chapter 13: Ethernet Ring Protection
- Published: 2013-02-13 1
- END USER LICENSE AGREEMENT 2
- Abbreviated Table of Contents 3
- Table of Contents 5
- Part 4 Index 8
- List of Figures 9
- List of Tables 11
- About This Guide 13
- Objectives 14
- Audience 14
- Supported Routing Platforms 15
- Using the Indexes 15
- Documentation Conventions 16
- Table 1: Notice Icons 17
- Documentation Feedback 18
- Requesting Technical Support 18
- Opening a Case with JTAC 19
- Overview 21
- Ethernet Terms and Acronyms 23
- 192.168.27.48 28
- 0x8100. This is not the VLAN 31
- Layer 2 Networking Standards 37
- CHAPTER 2 41
- Example Scenario 43
- Example Configuration Summary 44
- Configure MSTP on Router 3: 53
- Virtual Switches 59
- Chapter 3: Virtual Switches 61
- Environments 63
- Configuring a Normalized VLAN 66
- CHAPTER 5 83
- Protocols 87
- CHAPTER 7 99
- • DHCP Relay Agent 102
- Interworking Function 103
- Router PE2 107
- Configuration 107
- Router PE1 109
- • ATM Ethernet Interworking 117
- Layer 2 Firewall Filters 121
- • Layer 2 Firewall Filters 128
- Management 129
- Configuration of P 136
- MPLS only, no CFM needed: 136
- CFM on PE1 [edit interfaces] 139
- CFM on PE2 [edit interfaces] 140
- Documentation 141
- Ethernet OAM• 141
- • Ethernet OAM 143
- Measurements 145
- Single-Tagged Interfaces 151
- Configuration on Router MX-1: 152
- Configuration on Router MX-2: 152
- MX-1 and MX-2 160
- IEEE 802.3ah OAM Link-Fault 163
- Ethernet Ring Protection 171
- Example Topology 174
- 1. Configure the interfaces: 175
- Configure Ethernet OAM: 176
- Router 2 Configuration 177
- Router 3 Configuration 178
- Configure the bridge domain: 179
- Requirements 181
- Overview and Topology 181
- MX Series Routers 182
- SettingsProperty 183
- Configuring ERP on CS2 187
- Configuring ERP on AS1 190
- Verification 192
- Verifying the VLANs on CS1 194
- Verifying the VLANs on CS2 195
- Verifying the VLANs on AS1 197
- Index on page 185 203
Relacionado con productos y manuales para Hardware Juniper-networks JUNOS OS 10.4
Hardware Juniper-networks SSG 20 Manual de usuario
(86 paginas)
(86 paginas)
Hardware Juniper-networks ERX-1410 Manual de usuario
(184 paginas)
(184 paginas)
Hardware Juniper-networks E-Series Manual de usuario
(242 paginas)
(242 paginas)
Hardware Juniper-networks M20 Manual de usuario
(34 paginas)
(34 paginas)
Hardware Juniper-networks J4350 Manual de usuario
(284 paginas)
(284 paginas)
Hardware Juniper-networks M7I Manual de usuario
(105 paginas)
(105 paginas)
Hardware Juniper-networks V10000 Manual de usuario
(12 paginas)
(12 paginas)
Hardware Juniper-networks 5000 Manual de usuario
(66 paginas)
(66 paginas)
Hardware Juniper-networks M40e Manual de usuario
(22 paginas)
(22 paginas)
Hardware Juniper-networks J-Series Manual de usuario
(332 paginas)
(332 paginas)
Hardware Juniper-networks SRX 210 Manual de usuario
(176 paginas)
(176 paginas)
Hardware Juniper-networks M5 Manual de usuario
(205 paginas)
(205 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.050 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales