Juniper-networks M20 Manual de usuario

Busca en linea o descarga Manual de usuario para Hardware Juniper-networks M20. Juniper Networks M20 User Manual Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 34
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
M20 Internet Router
PIC Guide
End-of-Life PICs
Juniper Networks, Inc.
1194 North Mathilda Avenue
Sunnyvale, California 94089
USA
408-745-2000
www.juniper.net
Part Number: 530-010561-01, Revision 7
Vista de pagina 0
1 2 3 4 5 6 ... 33 34

Indice de contenidos

Pagina 1 - PIC Guide

M20 Internet RouterPIC GuideEnd-of-Life PICsJuniper Networks, Inc.1194 North Mathilda AvenueSunnyvale, California 94089USA408-745-2000www.juniper.netP

Pagina 2

ATM OC3 PIC JUNOS 3.1 and laterSoftware release Two OC3 ports Power requirement: 0.49 A @ 48 V (23.7 W) Conforms to ANSI T1.105-1991 and T1E1.2/93-020

Pagina 3

One tricolor per port: Off—Not enabled Green—Online with no alarms or failures Amber—Online with alarms for remote failures Red—Active with a local al

Pagina 4 - Adaptive Services PIC

ATM OC12 PIC JUNOS 3.1 and laterSoftware release One OC12 port Power requirement: 0.43 A @ 48 V (20.8 W) Conforms to ANSI T1.105-1991 and T1E1.2/93-02

Pagina 5 - Adaptive Services PIC ■ 5

Alarm indication signal (AIS-L, AIS-P) Bit error rate signal degrade (BERR-SD), Bit error rate signal fail (BERR-SF) Bit interleaved parity errors B1

Pagina 6 - ATM DS3 PIC

Channelized DS3 PIC JUNOS 4.2 and laterSoftware release Four DS3 ports Power requirement: 0.32 A @ 48 V (15.6 W) Supports up to 28 T1 channels per por

Pagina 7 - ATM DS3 PIC ■ 7

Alarm Indication Signal (AIS) Bit error rate (BER) Equipment failure (Does not affect service) Excessive zeros (EXZ) Far-end Block Error (FEBE) Frame

Pagina 8 - ATM E3 PIC

Channelized E1 PIC JUNOS 5.1 and laterSoftware release Ten E1 ports Power requirement: 0.15 A/48 V @ 7.2 W Supports up to 24 NxDS0 channels per port D

Pagina 9 - ATM E3 PIC ■ 9

Channelized STM1 to E1 PIC JUNOS 4.4 and laterSoftware release Four E3 ports Power requirement: 0.32 A/48 V @ 15.3 W 63 E1 channelsDescription Each E1

Pagina 10 - ATM OC3 PIC

Single-mode fiber Duplex SC/PC connector (RX and TX)Cables and connectorsOne tricolor per port: Off—Not enabled Green—Online with no alarms or failur

Pagina 11 - ATM OC3 PIC ■ 11

E3 PIC JUNOS 3.1 and laterSoftware release Four E3 ports Power requirement: 0.47 A @ 48 V (22.5 W) Integrated DSU interoperabilityDescription High-den

Pagina 12 - ATM OC12 PIC

This guide provides an overview and description of the Physical Interface Cards (PICs)supported by the Juniper Networks M20 Internet router that are e

Pagina 13 - ATM OC12 PIC ■ 13

Alarm indication signal (AIS) Equipment failure (does not affect service) Frame error Line code violation Loss of signal (LOS) Out of frame (OOF) Yel

Pagina 14 - Channelized DS3 PIC

Gigabit Ethernet PIC JUNOS 3.2 and laterSoftware release One Gigabit Ethernet port Power requirement: Supports large Ethernet frame sizes for more eff

Pagina 15 - Channelized DS3 PIC ■ 15

Table 4: Optical Interface Support for Gigabit Ethernet PICsLH TransceiverLX TransceiverSX TransceiverPIC Type43.5 miles/70 kmreach on 9/125micrometer

Pagina 16 - Channelized E1 PIC

Gigabit Ethernet PIC (Quad-Wide) JUNOS 4.2 and laterSoftware release Four Gigabit Ethernet ports Power requirements: 0.40 A @ 48 V (19.2 W) Supports l

Pagina 17 - Channelized STM1 to E1 PIC

Status LEDs, one bicolor: Off—PIC not enabled Green—PIC is operating normally Red—PIC has an error or failurePort LEDs, one pair per port: Link—If gre

Pagina 18

Monitoring Services PIC JUNOS 5.6 and laterSoftware release Active traffic monitoring Power requirement: 0.19 A @ 48 V (9 W) Monitors IPv4 packets Sup

Pagina 19 - E3 PIC ■ 19

Multichannel DS3 PIC JUNOS 5.1 and laterSoftware release Two DS3 ports Power requirement: 0.31 A @ 48 V (14.9 W) Supports up to 128 logical customer c

Pagina 20 - 20 ■ E3 PIC

Far-end block error (FEBE) Parity bit (P-bit) disagreements Path priority error Alarm indication signal (AIS) Loss of signal (LOS) Out of frame (OOF)

Pagina 21 - Gigabit Ethernet PIC

Multilink Services PIC JUNOS 4.3 and laterSoftware release Power requirement: 0.17 A/48 V= 8 W Available versions: 4 multilink bundles 32 multilink bu

Pagina 22 - 22 ■ Gigabit Ethernet PIC

One bicolor: Off—PIC is offline Green—PIC is online and at least one configured bundle is operating Amber—PIC is online, but no configured bundles are

Pagina 23

Table 1: End-of-Life PICs Supported in the M20 Internet RouterPagePICSlots RequiredFirst JUNOS SupportPortsPIC Family and TypeATM61 slot4.34ATM DS381

Pagina 24

SONET/SDH OC48c/STM16 PIC (Quad-Wide) JUNOS 4.1 and laterSoftware release One OC48 port Power requirements: 0.86 A @ 48 V (41.4 W)Description Multiple

Pagina 25 - Monitoring Services PIC

Duplex LC/PC Connector (Rx and Tx) Optical interface support—see Table 6 on page 33NOTE: To extend the life of the laser, when a PIC is not being act

Pagina 26 - Multichannel DS3 PIC

SONET alarms: Alarm indication signal—line (AIS-L) Alarm indication signal—path (AIS-P) Bit error rate signal degrade (BERR-SD) Bit error rate signal

Pagina 27 - Multichannel DS3 PIC ■ 27

Table 6: Optical Interface Support for SONET/SDH OC48c/STM16 PICsSingle-mode Long Reach (LR)Single-mode Intermediate Reach(IR)Single-mode Short Reach

Pagina 28 - Multilink Services PIC

This product includes the Envoy SNMP Engine, developed by Epilogue Technology, an Integrated Systems Company. Copyright © 1986-1997, EpilogueTechnolog

Pagina 29 - Off—PIC is offline

Adaptive Services PIC JUNOS 6.0 and laterSoftware release Supports tunnel services. This feature is included with the PIC and does not require anindiv

Pagina 30

Status LED, one tricolor: Off—PIC is offline and it is safe to remove it from the chassis. Green—PIC is operating normally. Amber—PIC is initializing.

Pagina 31

ATM DS3 PIC JUNOS 4.3 and laterSoftware release Four DS3 ports Power requirement: 0.39 A @ 48 V (19 W) Conforms to ANSI T1.105-1991 and T1E1.2/93-020R

Pagina 32

Multiprotocol Label Switching (MPLS) circuit cross-connect (CCC) for leveraging ATMaccess networks Support for user-configurable virtual circuits (VC

Pagina 33

ATM E3 PIC JUNOS 4.3 and laterSoftware release Four E3 ports Power requirement: 0.43 A @ 48 V (20.8 W) Conforms to ANSI T1.105-1991 and T1E1.2/93-020R

Pagina 34

Multiprotocol Label Switching (MPLS) circuit cross-connect (CCC) for leveraging ATMaccess networks Support for user-configurable virtual circuits (VC

Comentarios a estos manuales

Sin comentarios