Juniper-networks ERX-1410 Manual de usuario descargar pdf (Pagina 55)

Installing SRP I/O and SRP Modules

ERX Edge Routers

3-9

Caution: Always handle the module by its edges. Do not touch the components,

pins, leads, or solder connections.

5 Remove the SRP module from its antistatic bag.

6 Make sure that the ejectors are in position 1, as shown in Figure 3-7.

Figure 3-7 Positioning the ejectors

7 Position the module as follows:

• For the ERX-1400 series, position the module vertically so that

the labeling is upright.

• For the ERX-700 series, position the module horizontally so that

the labeling is to the right.

8 Position the module in the chassis by placing it between the guides of

the selected slot, and slide the module until it stops.

The module stops sliding when the ejectors make contact with the

front of the chassis. Figure 3-8 shows how to install an SRP module

in the ERX-1400 series.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 183 184

Sin comentarios

Juniper-networks ERX-1410 Manual de usuario Pagina 55