Juniper Networks MX240 Manual de usuario descargar pdf (Pagina 104)

NOTE: A DPC weighs 13.1 lb (5.9 kg). Be prepared to accept the full weight of the

DPC as you lift it.

To hold a DPC vertically:

1. Orient the DPC so that the faceplate faces you. To verify orientation, confirm

that the text on the DPC is right-side up and the electromagnetic interference

(EMI) strip is on the right-hand side.

2. Place one hand around the DPC faceplate about a quarter of the way down from

the top edge. To avoid deforming the EMI shielding strip, do not press hard on

it.

3. Place your other hand at the bottom edge of the DPC.

If the DPC is horizontal before you grasp it, place your left hand around the faceplate

and your right hand along the bottom edge.

To hold a DPC horizontally:

1. Orient the DPC so that the faceplate faces you.

2. Grasp the top edge with your left hand and the bottom edge with your right hand.

You can rest the faceplate of the DPC against your body as you carry it.

As you carry the DPC, do not bump it against anything. DPC components are fragile.

Never hold or grasp the DPC anywhere except places that this document indicates.

In particular, never grasp the connector edge, especially at the power connector in

the corner where the connector and bottom edges meet (see Figure 33 on page 76).

Figure 33: Do Not Grasp the Connector Edge

76 ■ Maintaining Packet Forwarding Engine Components

MX240 Ethernet Services Router Hardware Guide

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 241 242

Sin comentarios

Juniper Networks MX240 Manual de usuario Pagina 104