Juniper-networks T1600 Manual de usuario Pagina 34

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 151
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 33
Multiprotocol Label Switching (MPLS) circuit cross-connect for leveraging ATM access networks
User-configurable virtual circuit (VC) and virtual path (VP) support
Support for idle cell or unassigned cell transmission
OAM Fault Management processes Alarm Indication Signal (AIS), Remote Defect Indicator
(RDI), and loop cells
Point-to-point and point-to-multipoint mode Layer 2 counters per VC and per VP
Local and remote loopback
ATM Inverse ARP, which enables routers to automatically learn the IP address of the router on
the far end of an ATM PVC
Simple Network Management Protocol (SNMP):
Management Information Base (MIB) 2 (RFC 1213)
ATM MIB (RFC 1695)
SONET MIB
Unspecified bit rate (UBR), non-real-time variable bit rate (VBR), and constant bit rate (CBR)
traffic shaping
Per-VC or per-VP traffic shaping
Support for F4 OAM cells
Support for 16-bit VCI range
Software features
You can install different transceivers on the PIC.
Duplex LC/PC connector (RX and TX)
SONET/SDH OC48/STM16 fiber-optic SFP transceivers:
Multimode (model number: SFP-OC48-SR)
Intermediate reach (IR-1) (model number: SFP-OC48-IR)
Optical interface specifications—see SONET/SDH OC48/STM16 Optical Interface Specifications
Cables and connectors
One tricolor per port:
Off—Not enabled
Green—Online with no alarms or failures
Yellow—Online with alarms for remote failures
Red—Active with a local alarm; router has detected a failure
LEDs
Copyright © 2013, Juniper Networks, Inc.34
T1600 Core Router Interface Module Reference
Vista de pagina 33
1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 150 151

Comentarios a estos manuales

Sin comentarios