Juniper-networks Juniper M-series M7i Manual de usuario descargar pdf (Pagina 9)

Figure 5: Connect External Devices and PIC Cables to Router

Connect a Management Console or Auxiliary Device

1. Turn off the power to the console or auxiliary device.

Plug the female end of the RS-232 serial connector into the CONSOLE or

AUX/MODEM port.

3. Use a 2.5 mm flat-blade screwdriver to tighten the screws on the connector.

4. Connect the other end of the cable to the console or auxiliary device.

Connect to a Network for Out-of-Band Management

1. Turn off the power to the networking device.

Plug one end of the Ethernet cable (with RJ-45/RJ-45 connectors) into the MGMT

port on the Routing Engine.

3. Plug the other end into the networking device.

Connect FIC and PIC Cables

WARNING: Do not look directly into a fiber-optic transceiver or into the ends of

fiber-optic cables connected to a transceiver. Fiber-optic transceivers contain laser

light sources that can damage your eyes.

Step 4: Connect External Devices and PIC Cables ■ 9

Step 4: Connect External Devices and PIC Cables

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 22 23

Sin comentarios

Juniper-networks Juniper M-series M7i Manual de usuario Pagina 9