Juniper Networks M10 Manual de usuario Pagina 140
- Pagina / 205
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Replace Routing E
ngine Components
1. If a cable is already installed in the CONSOLE or AUX/MODEM port, perform the
following steps:
a. Turn off the power to the console or auxiliary device.
b. Unscrewthescrewsthatsecurethecableconnectortotheport,usinga2.5-mm
flat-blade s
crewdriver if necessary.
c. Pull the ca
ble connector straight out of the port.
d. Disconne
ct the cable from the console or auxiliary d evice.
2. Plug the fem
ale end of the replacement serial cable into the appropriate CONSOLE or
AUX/MODEM por t. Figure 44 shows the external d evice ports on the craft interface.
3. Tighten the screws on the connector, using a 2.5-mm flat-blade screwdriver if necessary.
4. Power on the auxiliary or console device.
Figure 46: Serial Port Connector
1027
120 M5 and M10 Internet Routers Hardware Guide
- M5 and M10 Internet 1
- Router s 1
- Table of Con 3
- Chapter 3 4
- Chapter 4 4
- Chapter 5 4
- Chapter 6 5
- Chapter 7 5
- Chapter 8 5
- Chapter 9 6
- Ta ble o f Con t e n ts 9
- List of Figures 11
- List of Tables 13
- List of Ta bles 14
- About This Manual 15
- Documentation Co 16
- Notes, Cautions, and Warnings 17
- List of Technical 18
- Publications 18
- Documentation Feedback 19
- How to Request Support 19
- How to Request Sup 20
- Product Overview 21
- Chapter 1 23
- Safety Requireme 24
- Chapter 2 25
- Figure 1: Front of M5 Chassis 26
- Description Va lue 27
- Packet Forwardin 28
- Routing Engine 32
- Craft Interface 34
- Power Supplies 36
- • AC Power Suppl 37
- • DC Powe r Supply on page 18 37
- AC Power Supply 37
- DC Power Supply 38
- Fan Tray 39
- Cable M anag 40
- Routing Engine So 42
- Tools for Monitor 47
- Software Upgrades 48
- Routing Engine Ar 52
- Initial Installation 55
- Rack Requirement 58
- 19 in. (48.3 cm) 59
- 17.5" 60
- 19" 60
- Fire Safety Requirements 61
- Fire Suppression 61
- Fire Suppression Equipment 61
- Power Guidelines 62
- Router Power Requirements 63
- Network Cable Spe 68
- Site Preparation Checklist 72
- Site Preparation 73
- Checklist 73
- Unpack the Router 76
- Choose Front or Ce 77
- Install the Chass 80
- Connect the Route 82
- Connect PIC Cables 83
- Connect PIC Cable 84
- Provide Power to t 85
- Power On the Router 87
- Configure the JUN 89
- OS Internet Software 89
- Procedures 93
- Maintain Packet F 96
- Maintain the Powe 98
- Maintain the Routing Engine 99
- Maintain the Rout 100
- Chapter 10 101
- Replace the Fan Tray 102
- Remove the Fan Tray 102
- Install the Fan Tray 103
- Replace Packet Fo 104
- • Remove a PIC on page 87 107
- • Install a PIC on page 89 107
- Replace a P 107
- • Issue the foll 108
- • For a qu 109
- • For a quad-wid 110
- Replace an SFP 115
- • Remove a 115
- • Install an SFP on page 96 115
- • If the PIC has 117
- Replace Power Sys 118
- • Install an AC Po 119
- ReplaceanACPowerCord 123
- Replace a DC Powe r Supply 124
- • Insert the po 127
- Replace Routing E 132
- Replace the Routing Engine 135
- • Replac 138
- Chapter 11 141
- Overview of Troub 142
- Troubleshoot Pac 144
- Troubleshoot the 145
- Power System 145
- LEDonBothSuppliesIsOff 146
- LED on O ne Supply Is Off 146
- • If it is lit 146
- Appendixes 147
- Appendix A 149
- Definition of Saf 150
- Safety Guideline 151
- Safety Guidelin e 152
- Agency Approvals 180
- Compliance State 181
- United States 182
- Appendix B 183
- Locate Component 184
- Serial Numbers 184
- Routing E 187
- Pack the Ro 188
- Pack Components f 189
- Appendix C 191
- RJ-48 Cable Pinou 192
- Ethernet 10/100 BASE-TX 195
- RJ-21 Cable Pinou 196
Relacionado con productos y manuales para Redes Juniper Networks M10
Redes Juniper Networks EX2500 Manual de usuario
(102 paginas)
(102 paginas)
Redes Juniper Networks IDP250 Manual de usuario
(84 paginas)
(84 paginas)
Redes Juniper Networks J6350 Manual de usuario
(332 paginas)
(332 paginas)
Redes Juniper Networks 5000 Series Manual de usuario
(116 paginas)
(116 paginas)
Redes Juniper Networks 8 Manual de usuario
(183 paginas)
(183 paginas)
Redes Juniper Networks V10000 Manual de usuario
(12 paginas)
(12 paginas)
Redes Juniper Networks M120 Manual de usuario
(116 paginas)
(116 paginas)
Redes Juniper Networks 200 Series Manual de usuario
(40 paginas)
(40 paginas)
Redes Juniper Networks EX3200 Manual de usuario
(284 paginas)
(284 paginas)
Redes Juniper Networks EX2200 Manual de usuario
(176 paginas)
(176 paginas)
Redes Juniper Networks MX960 Manual de usuario
(16 paginas)
(16 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.052 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales