Juniper-networks Juniper M-series M10i Manual de usuario descargar pdf (Pagina 60)

SONET/SDH OC3c/STM1 PIC with SFP

■

JUNOS 8.4 and laterSoftware release

■

Two OC3c ports

■

Power requirement: 0.25 A @ 48 V (12 W)

Description

■

Multiplexing and demultiplexing

■

Rate policing on input

■

Rate shaping on output

■

Packet buffering, Layer 2 parsing

Hardware features

■

Optical diagnostics and related alarms

■

SONET/SDH framing

■

Link aggregation

■

Alarm and event counting and detection

■

Dual-router automatic protection switching (APS)

■

Multiprotocol Label Switching (MPLS) fast reroute

■

Encapsulations:

■

High-Level Data Link Control (HDLC)

■

Frame Relay

■

Circuit cross-connect (CCC)

■

Translational cross-connect (TCC)

■

Point-to-Point Protocol (PPP)

Software features

■

Duplex LC/PC connector (Rx and Tx)

■

Optical interface support—See Table 14 on page 61

NOTE: To extend the life of the laser, when a PIC is not being actively used with any valid

links, take the PIC offline until you are ready to establish a link to another device. For

information about taking a PIC offline, see the request chassis pic offline command in the

JUNOS System Basics and Services Command Reference.

Cables and connectors

One tricolor per port:

■

Off—Not enabled

■

Green—Online with no alarms or failures

■

Amber—Online with alarms for remote failures

■

Red—Active with a local alarm; router has detected a failure

LEDs

60 ■ SONET/SDH OC3c/STM1 PIC with SFP

M10i Internet Router PIC Guide

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 77 78

Comentarios a estos manuales

Sin comentarios

Juniper-networks Juniper M-series M10i Manual de usuario Pagina 60

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Juniper-networks Juniper M-series M10i