
J4350 and J6350 Services Router Getting Started Guide
The Gigabit Ethernet ePIM provides the following key features:
Full-duplex and half-duplex modes (built-in and Copper Gigabit Ethernet
ePIMS only)
Autonegotiat
ion through medium-dependent interface (MD I) and MDI
crossover (MDI–X) support
Gigabit Ethernet ePIMs do not support SNMP.
You can install G igabit Ethernet ePIMs in any hig h- speed slot as follows:
J4350—Install up to two Gigabit Ethernet ePIMs in slots 3 and 6.
J6350—Install up to four Gigabit Ethernet ePIMs in slots 2, 3, 5, and 6.
NOTE: High spee d slots are labeled with an E on the front-panel slot number
diagram.
Figure 10 shows the Copper Gigabit Ethernet ePIM.
Figure 10: Copper Gigabit Ethernet ePIM
10/100/1000
0
g003851
You can manually configure the Copper Gigabit Ethernet ePIM to
link speed
s of 10, 100, or 1000 Mbps, and you can configure the
transmission mode to half or full duplex.
For pinouts of cable connectors for Gigabit Ethernet ePIMs, see “RJ-45
ConnectorPinoutforGigabitEthernetPorts”onpage195.
Figure 11 shows the SFP Gigabit Ethernet ePIM.
32 Field-Replaceable PIMs
Comentarios a estos manuales